i have an iseki modelTS 1610. I have no idea where to look for information, parts or service. It is currently broke down, and the work is piling up. It is getting fire, cause it will start as long as i am pouring starting fluid in the breather. i believe that is not getting diesel. can someone help me with tips on troubleshooting, and where to find parts for this brand tractor, thank you, david b. nelson

In have a Iseki TS3510 I am looking for a new clutch plate and baring.

I UNDERSTAND THAT ISEKI BUILDS THE NEW MASSEY FURGUSON COMPACTS. YOU MIGHT TRY A MASSEY FURGUSON DEALER.

I have an Iseki 2210. If it has air in the line it wont go. On mine, there is a screw up by the ejectors I take out that helps bleed out the air. Once I do that it starts great. Iseki also makes Bolens tractors but I dont think they can help much. I actually called Japan and no manual was available for mine.

Mine has 2 places to drain the air. One down by the feul shutoff and one up by the injector.

Don't know much about them,only that the small WHITE tractors are made by Iseki. Maybe they could help you to find parts.

More info needed. Did you shut it down and it won't restart or did it shut itself down? If it shut down, was it out of fuel? Have you made certain the water level in the fuel isn't too high ( if it is, at this point you may have big problems). If it shut itself down with fuel in the tank, most likely you have either water or a fuel restriction (plugged filter, wad of gunk in tank outlet). And like GEO says, making it run on starting fluid is a very bad idea. Also if it is getting fuel, you get lots of blue smoke during cranking when there is no start. If the smoke isn't there, there is either no fuel or no compression.

We are a Iseki dealer and have parts or can order parts from japan. Let us know what you need.

I have a Bolens and I have heard it may have been made by iseki. Is that a possibility? If so, do they have some common parts? Thank You....Bobby

I HAVE AN ISEKI TS1700. IT RUNS HOT. I HAVE CHANGED THE COOLANT, FLUSHED THE RADIATOR, PUT IN A NEW THERMOSTAT, AND IT STILL RUNS HOT. WHAT IS THE PROPER THERMOSTAT FOR IT? ANY SUGGESTIONS WILL BE APPRECIATED.

have an iseki tractor and need a service manual
and an owners manual urgently.no one can tell me
whether to use hydraulic fluid or hydraulic oil
and it's very low.please respond as quickly as possible. thank you mike

Have iseke tractor model 2300. Need instruction book in English.

FOR MANUALS & MABE PARTS YOU MIGHT TRY WWW.HOMESTEADTRACTOR.COM

I fear that you have damaged the engine with starting fluid. If and when you get the system bled of air and the engine appears to have excessive blow by when running or attempts to run. The pistons will probably have the ring grooves sheared. These little engines can't handle starting fluid like some of the larger older engines can. Good luck.
Might try Greymarket parts at 1-800-700-4739
GEO

Can't help you on parts, but I can give a couple of troubleshooting tips. I think you're on the right track, it's probably not getting fuel.

Has it run out of fuel lately? If you got air in the fuel lines, you'll have to bleed them. The problem is when the fuel pump discharges into the line, the air compresses and the injector won't fire. (air will compress, liquid won't, with air in the line the pump can't build enough pressure to lift the injector) The usual method is to crack the fuel line at each injector and crank until you get a solid stream of fuel. You might want to do that anyway, to make sure the pump is working.

If that's not it, check to make sure the fuel lines to the pump are clear, the filter is clean and flowing freely, and there are no air leaks.

If that's not it, either the pump is shot or the timing is off, and I don't have any pointers there.

Hope this helps a little. Good luck.